Weigh out all the ingredients neatly and set them ready before you begin.

Mix the glycerine together with the xanthan gum and set aside.

Add the essential oils to the Coco Glucoside and mix until it is fully integrated.

Test the pH value and make sure it is between 3 and 8 with the use of preservative Leucidal.

Measure the pH again by mixing 1 gram of cleanser with 9 grams of demineralised water. The pH value should come out at 5.5 for sensitive skin, but may come out between 5.5 and 6.5 for blemished skin. Is the pH too low? Then add a baking soda solution to raise it (90% demineralised water + 10% baking soda). Do this drop by drop with a pipette. 10 drops is often good for a 0.5-1 rise in pH. Is the pH too high? Then do the same, but with citric acid (10% citric acid + 90% demineralised water). Each time make a dilution of your cream of 1 gram with 9 grams of demineralised water until the correct pH has been reached.

Use 1 to 2 pumps of cleanser on damp skin. Wash the face for at least 60 seconds before you rinse it off with lukewarm/warm water. After drying, use a toner to bring back some extra moisture to the cleansed skin.